Jan 31, 2025 Leave a message

Troubleshooting method of double blade mining machine

Risks of using double blade mining machine

Troubleshooting method of double blade mining machine

 

Maintaining and troubleshooting a double blade mining machine is crucial for ensuring its longevity and optimal performance. Here are some key troubleshooting methods and maintenance tips based on recent guides and resources:

 

1. Regular Cleaning and Lubrication

Cleaning: After each use, thoroughly clean the machine to remove debris, dust, or stone particles. Use compressed air or brushes to clean hard-to-reach areas.

Lubrication: Lubricate all moving parts to prevent friction and wear. Apply a suitable lubricant according to the manufacturer's recommendations.

 

2. Inspection and Replacement of Blades

Blade Inspection: Regularly inspect the blades for signs of wear, such as dull edges, cracks, or missing teeth. Replace the blades immediately if any defects are detected.

Spare Blades: Keep spare blades on hand to avoid interruptions in production. Properly aligned and sharp blades enhance cutting performance and maintain the machine's integrity.

 

3. Maintenance of Hydraulic System

Hydraulic Fluid Levels: Check the hydraulic fluid levels regularly and top up if necessary. Use 46# hydraulic oil in summer and 30# hydraulic oil in winter.

Hose Inspection: Inspect hydraulic hoses for any signs of wear or damage. Replace any damaged or leaking hoses immediately.

Filter Cleaning: Clean the hydraulic filters regularly to ensure proper filtration and remove any contaminants that could affect the system's performance.

 

4. Electrical System Check

Multimeter: Use a multimeter to check the electrical system, including connections, cables, and components.

Insulation Tape: Keep insulation tape handy to repair or cover any damaged electrical cables.

 

5. Common Faults and Solutions

Machine Not Moving Forward/Backward:

Relay Burnout: Replace the relay.

Faulty Travel Motor: Repair or replace the travel motor.

Faulty Inverter: Repair or replace the inverter.

 

3P Circuit Breaker Tripping:

Short Circuit in Oil Pump Motor: Replace the oil pump motor.

Short Circuit in Input Line: Check and replace the oil pump motor input line.

Short Circuit in Contactor: Replace the contactor.

 

Overloading During Cutting:

Monitor Current: During the cutting process, monitor whether the current is overloaded. If it exceeds the range, stop the machine in time.

Knife Jamming or Blade Clamping:

Emergency Stop: If the machine encounters knife jamming or blade clamping during cutting, quickly press the emergency stop button. Do not start the main motor again before the saw blade is lifted.

 

General Equipment Failure:

Professional Maintenance: If there is an equipment failure during the cutting process, quickly press the emergency stop button and continue cutting after professional maintenance personnel have eliminated the fault.

 

 

Send Inquiry

Follow Us

whatsapp

Phone

E-mail

Inquiry