Troubleshooting method of infrared bridge stone cutting machine
Infrared Bridge Stone Cutting Machines are advanced tools designed for high-precision cutting of stone materials. However, like any machinery, they can encounter issues that require troubleshooting. Here are some common problems and their solutions:
Workbench Issues
Workbench Cannot Be Raised or Rotated:
Possible Causes: Hydraulic system issues, worn seals, or electrical faults.
Solutions: Check the hydraulic fluid level and replace any worn seals. Inspect the electrical connections and replace faulty components.
Workbench Deviates During Cutting:
Possible Causes: Misaligned guide rails or worn components.
Solutions: Inspect and realign the guide rails. Replace any worn components.
Cutting Blade Issues
Saw Blade Feed Out of Control:
Possible Causes: Faulty transmission gear or damaged half-moon key.
Solutions: Replace the transmission gear or half-moon key.
Large Swing of the Saw Blade:
Possible Causes: Damaged output shaft bearings, worn clamp plate, or poor blade installation.
Solutions: Replace the bearings, clamp plate, or reinstall the blade correctly.
Motor and Power Issues
Motor Runs but Blade Does Not Rotate:
Possible Causes: Faulty transmission gear or damaged half-moon key.
Solutions: Replace the transmission gear or half-moon key.
Low Cutting Speed:
Possible Causes: Loose belt tension, dull saw blade, or low power supply voltage.
Solutions: Tighten the belt, sharpen the saw blade, or ensure the machine operates at the rated voltage.
Electrical and Control Issues
Possible Causes: Rusty button contacts or loose relay connections.
Solutions: Frequently inspect and clean rusty spots. Replace relays if they have poor contact.
PLC Control System:
Possible Causes: Faulty relays or loose connections.
Solutions: Inspect and replace faulty relays. Ensure all connections are secure.













