The steps to replace the cutting disc are as follows:

Power off
Make sure the Angle grinder is completely turned off and unplug the power to ensure safety.
Remove the old disc
Using the special wrench that came with the Angle grinder, loosen the nut holding the disc and remove the old disc.
Check the new disc
Make sure the new disc is free of damage, fits your tool, and matches the dimensions of the Angle grinder.
Install the new disc
Align the new disc with the shaft of the Angle grinder and gently place it in the correct position.
Fixed disc
Tighten the nut of the new disc by hand or with a special wrench to ensure that the disc is firm and not loose.
Test disc
After installing the new disc, turn on the Angle grinder and let it idle for a few seconds to check whether the disc is running smoothly.
Safety
During the entire process, remember to wear safety glasses and gloves to protect your eyes and hands.













